answersLogoWhite

0


Best Answer

Easy just cut to length & push on over barbs at each end. Take a sample to Napa or one of the better auto parts stores that sell vacuum size hoses & just but it by the foot. Usually there are 2 sizes- a smaller to both windshield washers & a larger size from the reservoir to the pump.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the hoses for the windshield wiper fluid?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the windshield wiper washer motor on a 1997 Oldsmobile cutlass?

Check either at the bottom of the windshield washer fluid reservoir or check to see if the wiper motor has washer hoses connected to it


How do I replace the windshield wiper switch?

How do I replace the windshield wiper switch?


How do you fix windshield wipers on a Volvo 940?

To fix windshield wipers on a Volvo 940 try using new wiper fluid and cleaning the windshield and wiper blades before you replace the blades. It is also important to replace wiper blades regularly.


Where is the windshield wiper fluid for the back glass located?

Fluid for my SUV (Envoy XUV) is fed from the same container that feeds the wiper fluid for the windshield.


How do you change wipers on 1995 Toyota Previa?

Turn the wiper on and cut the ignition power once the arm is in the 12 O'clock position (straight up and down) for easier access to the wiper. Disconnect rubber washer fluid hose from wiper. Lift arm off of the windshield, and notice where wiper connects to the arm, there's a small plastic locking lever. Squeeze to release, then remove wiper. may take some wiggling back and forth till it comes off. Once off, you can either replace the wiper refills, or replace the entire wiper blades with new ones. Note: the oem wiper blades have hoses on them which washer fluid flows through and squirts onto the windshield. So if you go with aftermarket blades, you will lose your wiper washer feature, and fluid will squirt everywhere unless you cap off the rubber hoses.


How do you replace front wiper on previa?

turn the wiper on and cut the ignition power once the arm is in the 12 O'clock position for easier access to the wiper. Disconnect rubber washer fluid hose from wiper. Lift arm off of the windshield, and notice where wiper connects to the arm, there's a small plastic locking lever. Squeeze to release, then remove wiper. may take some wiggling back and forth till it comes off. Once off, you can either replace the wiper refills, or replace the entire wiper blades with new ones. Note: the oem wiper blades have hoses on them which washer fluid flows through. So if you go with aftermarket blades, you will lose your wiper washer feature, and fluid will squirt everywhere unless you cap off the rubber hoses.


My windshield wiper goes off the windshield?

Replace the locking tab on top of the wiper


Where is the windshield wiper fluid reservoir on a 1997 Chevrolet Monte Carlo?

The 1997 Chevrolet Monte Carlo windshield wiper fluid reservoir can be found in the engine compartment. The windshield wiper fluid reservoir will be on the drivers side of the engine compartment.


What is the freezing point of windshield wiper fluid?

Windshield washer fluid has a freezing point of -40


Can Windshield wiper fluid freeze?

Yes


Is windshield wiper fluid a colloid?

No, it is a solution


How do you replace wiper switch l200 series?

2001saturn l200 how to replace a windshield wiper switch