Referring to the switch that turns the ignition on and off, not the key cylinder that operates the switch mechanism:
1. Remove the kick panel under the dash. Make note of how it comes out so you can put it back in.
2. Remove the trim panel under the steering column. If the car has column shift remove the clip that holds the shift indicator cable in place on the shift barrel, note its position.
3. Remove the four bolts that hold the steering column in place.
4. You can now lower the steering column. The ignition switch is mounted on the steering column.
5. The new switch should come with specific instructions on how to install it, follow those.
6. I would make sure it is working correctly before proceeding. Obviously don't start the engine and put the car in gear with the steering column out of place.
Reverse the above steps to put the steering column back in place. If your car has column shift be careful to put the shift indicator cable back in place. Check to see that the shift indicator is reading correctly.
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
very carefully
Retaining ring from the top of your 1979 Chevrolet Scottsdale ignition switch. Slide the switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
what is an ignition actuator i work on Chevrolet and have never heard of it are you talking about the switch
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
You can change your 1995 Chevrolet ignition switch by removing the ring at the top of the ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
You will need to remove the retaining ring at the top of your 1979 Chevrolet El Camino ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
You do not need a key to replace the ignition switch.
I'm told this is a common problem that Chevrolet is aware of. Contact your local dealer. They should be able to replace the ignition switch and charge it back to Chevrolet as a warranty repair.