answersLogoWhite

0


Best Answer

unhook neg battery cable then wait 10 mins for disgarge of capaciter then proceed to change ignition

User Avatar

Wiki User

โˆ™ 2012-11-03 18:11:32
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace the ignition switch on a 94 caravan How do you disarm the airbag?
Write your answer...
Submit
Related questions

How do you disarm driver airbag on 1994 Dodge Ram?

There is no way to disarm a driver airbag on a 1994 Dodge Ram. Most vehicles will only let a person disarm the passenger airbag.


Need to disarm airbag to change ignition how would you locate the airbag fuse if you have no owners manual for a 97 Saturn sl1?

You could just unhook your negative battery cable.


How do you disarm an airbag on an 98 Cadillac?

It is illegal to disarm an air bag.


How do you disarm an airbag on a 1996 Ford Taurus?

Remove the fuse.


How do you disarm an VW's airbag?

I wouldn't do that but if you unplug any of the sensors it will cause a fault which will disarm them. But you will get a warning light on your dash all the time.


How do you disarm the drivers side airbag on a 1997 Chevy silverado?

Don't do that!It's a major mistake to do that!The airbag is a safety device.


How do you disarm the P-S Airbag in your 97 Explorer?

The only way on that year model is to unplug it. You can go up above the glovebox, and you will see the connector. There is no disarm switch on that year Explorer. The airbag light is going to flash and illuminate after you do, but that is the only way.


Disarm 1998 Ford Contour alarm?

To disarm the alarm on the 1998 Ford Contour, simply turn on the ignition using the vehicle's key. You can also disarm the alarm using the key fob.


How do you change the ignition lock cylinder in a 2001 Chevrolet Tracker?

To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.


How do you disarm the airbag on a 1994 Mercury Grand Marquis?

Run it in to a tree???


How do you install an ignition key cylinder on a 1993 Grand Marquis?

you will see a small hole directly below the key cylinder turn the ignition to "run" not "on" put a wire or punch in the whole to disengage the retaining pin while pulling on the lock cylinder at the same time. ALSO DISCONNECT THE NEGATIVE BATTERY CABLE AND AS A PRECAUTION DISARM THE AIRBAG.


How do you disarm the driver side airbag on a 1997 Isuzu Rodeo and how to replace the instrument panel light bulbs?

Remove the fuse. Fuse box is located on the driver side of the dash, between the dash and driver side door.Note: The airbag is part of the safety systems in the car and should not be disarmed.


How to disarm your car alarm after installing a new car battery?

Insert the ignition key into the ignition and turn it to on, the alarm should shut off.


How do you disarm the alarm of a Subaru?

On older models you either need to use the remote or place the key in the ignition and turn it 3 times. It won't start because of the ignition kill until you disarm the alarm. On newer models you only have to turn the key once.


How do you disarm the airbag on a 94 camaro and remove the steering wheel?

simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.


Tundra alarm disarm?

2000 - 2002 Toyota tundra, You can disarm these tundra by Power up the Ignition 1 and Ignition 2 when you unlock, Part you neet are two diode and two relay to power up the Ign1 and Ign 2 by using the unlock or disarm wire. So whenever you unlock, there will be pulse to the dask light come on for only .8 second.


How do you disarm the alarm system on a 2000 Dodge Caravan?

The factory alarm is disarmed by unlocking the doors with a key or remote.


Disarming Driver Air Bag on a 1999 Tacoma?

The only way to disarm the drivers side airbag in a 1999 Tacoma is to pull all of the airbag fuses. You will have a constant flashing light on your dash once you pull these fuses.


Disarm passenger airbag in Mitsubishi l200?

The passenger airbag on a Mitsubishi L200 can easily be deactivated by flipping the switch located in the glove box. This feature is available to allow a rearward-facing child restraint to be used in that seat.


How do you disarm the airbag in a 1995 Chevrolet Camaro?

YOU DO NOT!!! YOU ARE ARE IN DANGEROUS TERRIORTY. ONLY THE DEALERSHIP CAN WORK ON THEM. If you are involved in an accident then the insurance company would not have to pay for your injuries.


How do you disarm a stock alarm on a 1997 Cougar if it is connected to the ignition-horn?

You can disarm your 1997 Mercury Cougar alarm system by removing the alarm system fuse. The alarm system fuse can be found in the fuse box.


How do you disarm the alarm on a 2001 Monte Carlo?

To disarm the alarm, you use the key to unlock either the front door, press the unlock button on the keyless entry transmitter. Insert a valid key into the ignition and switch the ON position.Ê


How do you disarm your security system on a 97 olds aurora?

To disarm the security system on a 1997 Oldsmobile Aurora, simply press the red button on the key fob. If the key fob is not available, insert the key into the ignition and turn.


How do you disarm your factory alarm on your Cadillac saden deville?

To disarm the factor alarm on a Cadillac Sedan Deville, place the key in the ignition and turn it slightly without starting the car. Leave it in that position for 10 minutes and turn the car on.


Where is turn signal switch on 98 explorer?

In the steering column. You'll have to remove the steering wheel with a steering wheel puller tool. This can be a dangerous repair job due to the airbag in the steering wheel. Get a Haynes or Chilton's manual for the details on how to do this as well as how to disarm the airbag system.