Want this question answered?
replace headlight on mazda sp20
Replace the whole light assembly Their are no bulbs it is neon light
Remove the nuts so you can take the assembly off. Replace the assembly with the new light bulbs and socket it together. Screw the nuts back on to secure it.
Do not touch the glass on new bulb because the oil on your fingers can make bulb burn out. Open hood, locate plastic connector that goes into head light assembly, turn to left to remove, swap bulbs, replace into headlight assembly.
To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.
You will need a Torx T15 driver and however many 921 bulbs you have burned out. There are 3 bulbs in the center high-mount brake light assembly. Remove the 3 Torx screws right on the face of the plastic bar and the assembly, with the 3 bulbs mounted, comes down. The bulbs pull straight out of their sockets. Push the new bulbs into the blade sockets. Put the assembly back in place and replace the 3 screws.
Open the trunk. Loosen the black thumb latch wing nuts that hold the tail light assembly in place. pull the tail light assembly out. You should be able to acces the tail light bulbs to replace them.
1994-2005 models: (1)remove the light assembly screws (lower the tailgate for access); (2)take the assembly out of the fender for access to the tail light bulbs. To remove the bulbs:(1)rotate the bulb socket to align the lugs and take the socket out of the housing; (2)carefully pry off the retaining clip and pull the bulb out of the socket; (3)installation is the reverse of removal. - Mazda Pickups Reapair Manual
The bulbs go in from the rear. You may have to remove the light asy, by removing the top plastic rivet and sliding the whole assembly toward the front to disengage the three plastic assembly tabs.
You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.
By removing the locks that hold the headlight assembly in place you can wiggle the headlight assembly out to gain access to the headlight bulbs for replacement.
no