Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
how do you change the light bulb over the license plate on 2000 eclipse
How do you replace the bulb in the mirror of a 2000 E320 Mercedes
How do you change the lamp on the license plate of a lincoln ls 2000?
How do you change the fuel filter on a 2000 Mercedes ml320? and where is it?
yes there is, just above rear plate.
Most of the lighting on the rear of the Geo is housed inside the rear lense assembly. By removing the series of Phillips head screws that holdl the lense in place, you should be able to remove the lense and thereby access the lamps.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
part 168
It is a simple white license plate with California in red cursive writing on the top. (that is the current one which has been used since about 2000 I think)
Get two #168 bulbs,open the hatch look on the passenger side behind the plate for the inset handle remove the screw ,pry off the plastic cover.the bulb holders are up in two cutouts behind the license plate squeez the conector and turn the bulb holder will come out .replace the bulb then replace the holder then replug the wire.ps dont drop the connector its a pain to get it out
Check out the related link for a DIY article including pictures on how to replace the cabin air filter on your Mercedes Benz.
Hard to see, but on my 96 Jeep Gr Cherokee there are two small screws next to each lamp on the outside.