It unscrews.
How do you replace a break light switch on 1995 Chevy Tahoe
you can find the switch on the back of the brake pedal.
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
no i did not replace head light switch
Remove the ring bezel from the front of the dash by gently pulling it. Then lift it over and to the left of the steering wheel and all that, would be holding it will be the light switch it self, then just unplug it. Remove and relace the same way you did up till this point. J.d.
The 1999 Chevrolet Malibu brake light switch can be found beneath the dashboard, next to the brake pedal. The brake light switch simply plugs in and out.
7.99 at autozone you have to order it .
To remove the rear light bezel on a 1992 Chevy Cavalier, start by opening the trunk and locating the screws or bolts securing the bezel. Remove these fasteners, typically found at the edges of the bezel. Once the screws are removed, gently pull the bezel away from the body of the car, being careful not to break any clips. Finally, disconnect any electrical connectors if necessary, and the bezel should come off easily.
Take the old one out and put the new one in...
Check the brake light switch on the brake pedal. Might have to replace it.
THERE IS A CHANCE IF THE DOME LIGHT IS STAYING ON IT IS NOT THE THE DOOR SWITCH, BUT WORN DOOR HINGE BUSHINGS,