Want this question answered?
In Mr. Tire, $65.00 up.
Not aligning the threads up correctly and forcing the lug nut onto the wheel stud will strip the lug nut.
You split the nut with a sharp chisel. Don't worry about the stud You will have to replace both anyway, just be careful with the wheel and your fingers.
You don't say exactly what stud. If it's a wheel stud, the old one can be pounded out, and a new one pulled into place simply by tightening the lug nut on it.
turn the car off Don't jack up the wheel until you loosen the lug nuts. Find some one who is good with a cutting torch, they can cut that nut off without damaging the rim. You will have to replace that stud or maybe the hub assembly.
You will have to drill or cut the stud off.
KIA lug nuts are the same as other lug nuts on other car makes. To remove or tighten them, use a standard lug nut wrench or the one found in the trunk of your KIA.
The bolt pattern is 5x5. The lug nut size for the stud thread is 14mm x 1.50
The lug studs are a press fit into the flange on the hub. To remove them simply tap it out with a hammer. Be sure there is clearance behind the stud for it to come out, that is it won't hit a component behind it, If necessary rotate the flange until the stud would clear. To replace the stud push it through the hole then you can use a lug nut to pull the splines on into the hole and seat it. You will need a spacer on the stud since the threads are not usually long enough for the lug nut to get all the way to the flange. The spacer has to have a hole in it big enough to go over the threads without catching on them.
are u looking for a lug bolt or nut cause the lug bolt cost like 2 bucks and the lug nut cost like 5 bucks
On either front or rear axle, there should be a hole in the backing plate or a spot where you can drive the old stud out. Either with a hammer and punch or an impact hammer. Put a new stud in the hole and draw it up with the nut.
You can try welding another lug to it, or you might have to cut the stud and replace it, if worst comes to worst.