Want this question answered?
Remove motor mounts and raise motor approximately 4 inches.
yes this will work but you might need to change your motor mounts
Not including Trans Mounts, Should be 2, on has 2 bushings in it, the one closer to the rear
I dont know what "bumbing" means but ill assume vibrating. Replace all 3 motor mounts and 1 transmission mount.
3 ----- 2 side and 1 front
The Largest engine that will fit the motor mounts in a 1988 Ford Bronco is a 351 Windsor engine. You can get custom motor mounts and what not to fit any engine, but it takes some creativity and welding. I have a 460 engine in my 1988 Bronco, but it took quite the time to fit it in.
You will need to unbolt the motor and transmission from their mounts. jack up the motor, drain and remove the lower oil pan. That should give you access to the pump. If your going to do it you might want to change your main barrings at the same time.
Not easily. manifolds are different, motor mounts will not interchange..........
they are both V8s, they should use the same motor mounts
No, but hear are the years that will work. 1988 to 1995 350 engines.
What size motor? What accessories do you have? BClear.
In the oil pan at the bottom of engine