Chevy Blazer S-10

How do you replace the oil sending unit on a 1992 Chevy Blazer S-10?

656667

Top Answer
User Avatar
Wiki User
Answered
2011-09-20 17:42:17
2011-09-20 17:42:17

Oil sending unit is under intake manifold, just behind the oil filter on the passenger side (difficult to see-use flashlight). Best option to change : Get everything to do an oil change, removal of the filter makes easier access.

Read more: http://wiki.answers.com/Where_is_the_oil_sending_unit_on_2000_Chevy_S-10_2.2#ixzz1YW1xsgYQ

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Find out what's wrong and replace the broken part. It's either a fuse, the sending unit (in the tank) the gauge (in the dash) or a damaged wire or connector.

No. A Chevy Blazer does not have a reset switch.

The ECM on a 1992 S10 Blazer is located below the glove box.

how do you replace a CV joint on a 1992 Chevy pickup?

Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.

You have to open the differential and remove the retaining pin from the spider gear to remove the axle shaft.

you most likely need to change them

The starter solenoid is attached to the starter.

Under the Dashboard on the Drivers side, has a Plastic Cover.

I live in DE and they wanted 12 to 15 hundred to do my 1992 blazer.

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

low pressure on you MAP sensor clean it or replace it

It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.

its in the gas tank..you have to drop the tank to get to it!!!

it is behind the destribuater at the firewall

You don't, it is done by the ECM (Engine Control Module).

should i push it off a cliff

The front wheel stud on a 1992 Chevy Blazer S10 can be changed by jacking the vehicle up, removing the wheel, and unbolting the caliper. The rotor assembly can then be removed, and the wheel stud pressed or hammered out of its seat.

Behind the passenger side kick panel or behind the glove compartment.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.