Car Computers and Sensors
Dodge Intrepid

How do you replace the output speed sensor on a 1999 Dodge Intrepid?

373839

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:28:37
2015-07-15 19:28:37

It is located in the transmission. Go to a Library and read about it, or to a parts store and buy a book.

the sensors are on your left side of the transmission and can be changed in a few minutes. you need a one inch socket to remove them. They are not too tight and when you replace them, do not over tighten them. change both sensors at the same time, they are about 50 bucks for both.

just lift one side up then crawl under the car on your back. use stands or additional support for your jack. crawl from the driver's side of the car. mrhouston.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how to replace a map sensor on a 2004 dodge intrepid.

where is the crankshaft sensor located on a 1993 dodge intrepid

The vehicle speed signal comes from the transmission output speed sensor.

I need detailed information on how to replace a starter for a 2000 dodge intrepid

It does not have a cable. The speed signal comes from the trasnmission output speed sensor.

The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.

where is torque conversion sensor on my 1997 didge intrepid?

The output speed sensor is on the drivers side of the transmission and to the rear. The input sensor and output sensor are beside each other but have different connector types. common symptoms of a failed output sensor are: Speedometer stops working or is intermittent, transmission is stuck in second gear ( limp mode ) .

Without knowing what sensors you are trying to replace, there is no answer. Please re ask question about a specific sensor.

Vehicle speed sensor malfunction. Most likely you have a failed output speed sensor on the transmission.Vehicle speed sensor malfunction. Most likely you have a failed output speed sensor on the transmission.

It doesn't have a mass airflow sensor.

The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.

Transmission is in limp mode and most likely it is the input or output sensor or a wiring problem to one of them.

It doesn't have a speedometer cable. The speed is calculated by the transmission computer using it's output speed sensor.

how to change oil pressure switch in 2001 Dodge Intrepid I need to look at a diagram

i have dodge intrapid 2.7l my 02 sensor light come on p0051

There are 4 in the exhaust system.

It is inside the trans, on the valve body.

O,YEA AND I FORGOT TO MENTION IT IS A 1993 DODGE INTREPID...

just unplug the wires going to it unscrew it. then insert new one then hook wires back up.

1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.

how do you replace a dipstick tube on a 96 dodge intrepid

More than likely, its your input and output speed sensor, If your speedo does not work, I can guarantee that is your problem..


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.