How do you replace the passenger rear window on my 2007 Honda accord?

Answer 1

I've just recently done this to my 96 Accord... electric windows

remove inner door trim (a couple of screws, inner door handle slides forward and then comes off easily, trim is held in place by clips that release if you yank hard enough:) ), peel plastic liner up (but do not fully remove - painfull to get back on) using a 10mm socket undo the bolts that hold the 2 plastic window clamps, window must be all the way down before you start any of this mind you. using a sharp hobby knife cut the silicone glue holding the remaining glass from the plastic clamps (I'm assuming your window was smashed) then use a small screwdriver as a chissel to knock the glass out. apply a generous amount on silicone glue (i used general purpose silastic) to the plastic window clamp and reattach clamp... I'm sure there is a propper method for installing... i have no idea what it is... the only tip i can give is... insert the glass from the inside of the door not the outside.... i spent a day and a half trying to wiggle it in from out side the door... tried putting it in from inside and i was done in 10 minutes flat... once glass is in the plastic clamps push it down nice and hard to make sure the glass is fully embeded in the clamps... the silastic i used said cures in 24 hours... full bond in 7 days... so I'll be testing my window this Saturday :)