repl with a 3/4 galvaniced pipe and hose clamp, 2" long use the same tread for the intake and work fine, done on my 1993 suburban and never leak again
no.
There is 2 of them and they are underneath the intake manifold. You will have to remove the intake manifold to replace them are even see them.
what is the cost to replace a 2001 v-8 manifold intake
The intake manifold is where the air and fuel mix and enter the engine. The exhaust manifold is where unspent gas and air exit the engine. In other words the intake manifold is where the engine breathes in and the exhaust manifold is how the engine exhales out.
your intake manifold gasket is cracked...replace it and you should be fine...if it continues you may have a bigger problem
You need to replace the manifold and use Felpro Gaskets.
There are 2 knock sensor on the 5.3L engine. And they are under the intake manifold. To get to them you will have to remove the whole top of the engine- INTAKE MANIFOLD. Why do you think they need replaced???? check engine light came on for 2 sensor
Yes, you must install a new intake manifold gasket.
if it is a v6 engine it is located underneath the intake manifold and you have to removed the manifold to replace it. if it is a 4 cylinder it is located on the back side of the engine block below the manifold
Remove intake manifold from top of engine. It's underneath See previous question about location of manifold
The intake manifold attaches to the heads of the engine and send an air and fuel mixture to the combustion chamber through the intake valves. The intake manifold is usually situated on the top of the motor.
it is located inside the intake manifold