the radiator is located in the front boot under the front black plastic cover, remove this and the bonnet lock. you have to empty the radiator from the valve at the bottom right hand corner. On UK Models remove 2 plastic undertrays, disconnet the fans, unbolt and take them out from below. Remove the two top radiator support straps (the rubber cushion should come away on the bracket, not stick to the Rad) Disconnet the two water pipes - they will probably come away from the bulkhead tubes easiest, disconnect temp sender. Lift the rad an inch and work free from bottom spigot mounts then move rad backwards and drop through to the ground.
Look at the bottom or rear of the radiator
The thermostat on a 1993 Toyota Celica can be found by following the outlet radiator hose. The thermostat on these cars are located at the bottom of the radiator.
where us it located and how to change it.
On a 1993 Toyota Camry Vienta, the thermostat can be easily located by following the lower radiator hose to the point where it attaches to the engine. When replacing the thermostat, always replace gaskets as well.
How do you replace a radiator in a 1993 suburban?
my 1993 Toyota Camry radiator had a hole in it it was overheating. I replaced the radiator. The car is still overheating where is the thermostat located. First, drain your coolant from the radiator. Find your lower radiator hose and follow it to the metal housing. This is the thermostat housing. Remove the 2 nuts with a 10mm wrench. Remove the thermostat and replace with new one and new gasket. Re-install and re-fill your radiator with new coolant. Drive the car with heater running. Allow the engine to cool and top off the radiator. Add coolant to the reservoir to halfway between Full and Low.
How do I replace the Inigtor for corola Toyota 1993?
At the top end of the lower radiator hose within the water outlet. I hope this helps you. Rob
bolt pattern for 1993 toyota celica starter
Passenger side, near the firewall. It is not difficult to replace, it is just very difficult to get to.
Almost all thermostats are located at the motor where the top radiator hose connects to the motor. Drain the coolant, remove the 2 bolts in the thermostat housing, replace the thermostat, and replace the housing and refill the radiator.
Should be located at bottom or rear of radiator or remove lower radiator hose