Remove the tire and wheel from your 1999 Mercury Cougar. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.
how do you remove the headliner from a 1999 mercury cougar
http://www.carquest.com/techbulletins/brakes/2001/CQB%2001-10.pdf
Yes , the 1999 Mercury Cougar is FRONT wheel drive
It's a bit buried. Note that the 1999 Mercury Cougar has no user-servicable barts.
remove dash replace bulb(instrument cluster)
relay R1 is for the fuel pump on a 1999 Mercury Cougar
According to the 1999 Mercury Cougar Owner Guide : ( 58.5 litres / 15.4 U.S. gallons )
The 1999 Mercury Cougar OBD 2 port is under driver side dash left of steering column
According to the 1999 Mercury Cougar Owner Guide the six disc CD changer ( if equipped ) is located in the luggage compartment
I was looking at the 1999 Mercury Cougar Owner Guide and it does not show that it has a gas cap warning light
Take off old water pump and put on new very easy.
Ebay, http://www.nextag.com/mercury-cougar-headlights/search-html, or just drive to your ford/mercury dealer.
The engine diagram for a 1999 Mercury Cougar is used in diagnosing and repairing problems. It gives the location of each component and its connection type.
how to remove the door panel on a 1992 mercury cougar
Brakes come in two types: disc or drum.See "Related Questions" below for coverage of both types...
On a 1999 Mercury Cougar : The ELECTRIC fuel pump is INSIDE the fuel tank It is installed through an access hole in the top of the fuel tank
The door lock, on your 1999 Mercury cougar, can be replaced by removing the inside door panel. The locking mechanism is easily visible and can be changed.
Conventional drum brakes.
It's grounded on the front of the Mercury Cougar frame next to the headlight assembly.
You can view the 1999 Mercury Cougar owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides
firewall 1-----2-----3 ( bank 1 ) 4-----5-----6 ( bank 2 ) front of 1999 Mercury Cougar ( V6 )
This is as complex procedure. I suggest you buy a repair manual if it is not obvious to you, and you don't have experience.
Why are you replacing the switch? If the fan works only on high speed, replace the fan resistor. There was a TSB for this.
Remove the rear speaker cover from your 1999 Mercury Cougar speaker. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the speaker. Reverse the process to install the new speaker.
can i see mecury Yes u can