3rd brake light. Remove torx head screws and detach light housing. twist bulb holder counterclockwise to remove the pull bulb out of holder. Installation is reverse. Tail/Backup lights. Open trunk compartment. and remove interior trim panels. remove the 5 plastic nuts and pull light housing away from the car. Depress the clip and turn bulb counterclockwise and remove from housing. Install is reverse.
Replace the bulbs
The light assy has to be removed to take the bulbs out.
The entire bottom panel (5 bolts) has to be removed in order to replace the light.
Replace the whole light assembly Their are no bulbs it is neon light
The bulbs screw in from the rear and if you can't get to the rear, you have to take the light assy off.
replace the flasher(underneath driver side dash panel)
You can use a rear end from a 2013 or 2014 camaro or ss camro to replace a rear end in a 2014 SS Camaro car.
Remove the screws that hold the covers in place. Replace bulbs!
The center brake light bulbs can be replaced by lifting up on the rear light assembly and pulling towards the front of the car. www.lextechautomotivellc.com
whats tools do i need to replace my rear struts on my 95 camaro
To change your rear tail lights on your Shogun Pinin you will need to open the back hatch. After you open the hatch you will see panels next to where the lights are. You remove those panels and you will see your light bulbs and be able to replace them.
You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.