answersLogoWhite

0


Best Answer

To replace the rear turn signal, you must locate the 2 plastic plugs in the tailgate's door jam. Remove these plugs with a flat head screw driver and you will see a screw inside the hole. These screws hold the brake-light/turn signal housing. Once you remove the screws ,the housing is held in by plastic hooks where it takes a pivoting motion to get it free. Once you have done this, you will notice 2 screws holding the bulb holder. Unscrew these screws to expose the 3 bulbs. Change the necessary bulb and be sure not to touch the bulb with your bare hands! If you touch the bulb, wipe it with a cloth or tissue to remove the oil left by your hands. Oil from your hands, as little as it is, can shorten the life of a bulb due to the heating up of the oil and weakening the bulb glass. Replace the housing back the way it was and you're finished changing the turn signal. Good luck.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the rear turn signal light on a 1999 Yukon?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How to Change a front signal light - Volvo 1999 S80?

how do you replace front left turn signal on a 2001, volvo, s80


How do you replace heater core on a 1999 Yukon?

i need 2 no how


Right turn signal does not work on my 1999 Buick Park Avenue?

Replace the light bulb, if you've already tried that, then the switch is bad.


How do you replace the rear turn signal on a 1999 Acura Integra?

When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.


How do you replace signal light flasher on 1999 blazer?

The signal and 4 way flashers are behind the plastic lower dash panel, aprox under the radio. The lower dash panel must be removed to gain access.


Why are your brake lights sticking on 1999 GMC Yukon?

Defective or misadjusted stop light switch?


How do you change front signal light bulb on 1999 Honda CRV?

To change the front signal light bulb on the 1999 Honda CRV, pry up the fender fastener to expose the bulb socket. Twist the bulb socket 90 degrees and remove from the assembly. Turn the burnt bulb counterclockwise and pull out. Replace with new bulb.


How do you replace turn signal flasher and where is it located?

What kind of car 1999 mercury mountaineer


Can you replace the 5.3 in a 2000 Silverado with a 5.7 from a 1999 Yukon?

Yeah, it's doable, but it won't be a simple drop-in swap.


How do i change turning signal light switch for Toyota Camry 1999?

The signal light switch, on your Toyota Camry, can be changed by unplugging the signal relay switch. Plug in the new relay switch.


Replace dash light on 1999 Honda Accord?

dash light location on a 1999 hound accord V6


How much does it cost to replace transmission seal on 1999 gmc Yukon?

It would depend on which seal. There are several seals. Some are easy to replace while others are difficult.