You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
You can replace the rear vent window on a 2001 Chevy Blazer LS 4x4, 2 door with Direct Fit Power Window Regulators.
you need to replace the window support struts.. get a set here http://www.gmpartsdirect.com
Pry up clip on ends and pull off.
how to open the rear window on a 1997 chevy blazer.
The route of the window washer fluid hose from the reservoir to the rear window on a 1998 Blazer is through the headliner. If the leak is in the fender well it might be possible to splice into the line where it splits off to get to the window in the rear.
To replace your window, you need to have the window rolled up. On the regulator(that is the little arm that connects to the metal peice on the bottom of the window) is 11mm bolts. If you take those four bolts out, the metal sleeve on the bottom will come off. Clean out the old silicon. Put in new. Replace bolts.
To replace the Ford Explorer rear window hinge, you have to buy a similar window hinge. Use a screwdriver to open the hinge and replace the hinge but fitting it in the window.
The plastic on the rear window motor of a 2001 S-10 Blazer is black. It surrounds the majority of the motor and is easily distinguishable from the metal.
The rear window lock on the 2000 Blazer might have gotten rusty and will not turn to unlock the window. Try spraying a lubricant like WD-40 into the door lock. Wait a few minutes and then try the key in the lock.
see related link
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.