Serpentine Belts
Ford Thunderbird
Toyota Matrix
Chevy Avalanche

How do you replace the serpentine belt on a 1989 Ford Thunderbird 3.8L?

91011

Top Answer
User Avatar
Wiki User
2008-08-26 06:12:36
2008-08-26 06:12:36

you need a serpentine belt remover. Its $20 at autozone...The pulley on the bottom left will pull up if you use the tool..its the small pulley on the bottom left...very easy with the right tool....takes three hours without it:] and a lot of cussing...

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Remove your idler pulley first. it is the pulley right next to the alternator.

User Avatar

LOOK! It is right there applying tension to the belt. If you can't find it, then you have no business attempting to replace it.

User Avatar

There is a CEL, Check Engine Light, on the 1989 Thunderbird.

User Avatar

I need daigram of 2001 ford focus se serpentine belt

User Avatar

How do you replace the trunk drain hoses on a 1965 thunderbird.

User Avatar

behind the engine in the transmission tunnel...

User Avatar

I need a diagram of 2003 ford crown victoria serpentine belt.

User Avatar

before it breaks and you get stranded

User Avatar

I need a diagram to replace the serpentine belt on my 2000 Ford Escort ZX2 DOHC. Where do I go to find this diagram specific to my car?

User Avatar

Ford Thunderbird was created in 1955.

User Avatar

When i bought my thunderbird the key to the ignition didnt fit the door locks so i had to replace the locks. That might be the best answer. :]

User Avatar

go check in iraq, you commie. comprendo?

User Avatar

Dont repair...just replace it for your safety!

User Avatar

According to one of Fords websites : For a 1989 Ford Thunderbird , 3.8 liter V6 engine : The spark plugs are gapped at ( .054 inch )

User Avatar

I finally went to the Ford parts department and they provided me with the diagram to replace the belt. Thanks anyway.

User Avatar

You can replace the locking cylinder, on your 1994 Ford Thunderbird, by removing the inside door panel. The locking mechanism will be visible with the door panel removed.

User Avatar

No, the latest ford thunderbird was produced in 2005. after that, they were discontinued :(

User Avatar

To remove the back seat on a 1989 Ford Thunderbird, the first step is to remove the back of the seat. The back is held in by bolts on each side. After the back is removed, the seat area should come out after removing the floor bolts.

User Avatar

CHECK THE HINGES. IF THEY ARE BENT YOU MAY NEED TO REPLACE THEM. THIS IS WHAT I HAD TO DO WITH MY T-BIRD AND THE DOOR SHUT BEAUTIFUL. GOOD LUCK!

User Avatar

what are the fuses in a 1986 Ford Thunderbird and what do they do

User Avatar

how do install a radio in my ford thunderbird?

User Avatar

need diagram of the sepentine belt and how it go on.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.