Cadillac Brougham

How do you replace the serpentine belt on a 1992 Cadillac Brougham V8 5.0?

212223

Top Answer
User Avatar
Wiki User
2015-07-15 19:35:49
2015-07-15 19:35:49

Pry the tensioner up to remove the tension on the belt. The schematic should be on the fan shroud. If not draw a schematic before removing the belt. Don't rely on memory.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

replace it or get the one in your dash fixed because they have a lot of bugs in those digital dashs not working right i had to replace mines in my 91 cadillac brougham. good luck.

User Avatar

how to replace a serpentine belt on 1992 grand am 2.3l

User Avatar

Preferably thru the fuel nozzle...

User Avatar

from a 1992 what please? in regards to your serpentine, the engine should, if your lucky have a diagram of how it goes.

User Avatar

Loosen the tensioner pulley on your 1992 Buick LeSabre. Take the serpentine belt off. Put the new serpentine belt on and tighten it down with the tensioner pulley.

User Avatar

I found the answer at http://autorepair.about.com/library/faqs/b1103f.htm

User Avatar

The 1990 through 1992 Cadillac dashboard wiring diagram can be obtained from most Cadillac dealerships. The diagram can also be found at most auto-parts stores.

User Avatar

Drop the gas tank I got the same car

User Avatar

How do you route a serpentine belt on a 1992 Cierra Oldsmobile

User Avatar

Now if we're talking ft wheel drive Fleetwoods 1989-1993. If its the Fleetwood Brougham 1980-1992

User Avatar

No such thing as a '92 CTS. Model wasn't released until 2003.

User Avatar

Begin by putting the new serpentine belt around the 1992 Mercedes-Benz engine pulleys. Tighten the serpentine belt with the tensioner pulley.

User Avatar

I would have it professionally done because the back glass is prone to breaking easily

User Avatar

how do i set my timeing on a 1992 cadillac v8 4.9 liter

User Avatar

By removing the gear box , then reinstalling it and finally removing the old belt and replace by a new one.

User Avatar

this one is easy.....put the car in the on position(not running) and within 5 sec tap the gass pedel to the floor 3 times. the light should blink when taken(doesnt always on mine though). that should reset it! 93 fleetwood brougham.......d-body

User Avatar

What kinda model, make? I just had to replace all my belts, serpentine and all... It was a pain, because my water pump went out and broke all the belts. -Jajo ;)

User Avatar

where does the camshaft sensor go in a 1992 Cadillac Sedan Deville?

User Avatar

It is squealing because it is loose or worn out. Tighten it and if that does not help, replace it. If it is a serpentine belt, just replace it and check to make sure the idler tensioner is working properly.

User Avatar

The cam on this engine is driven by a CHAIN and not a belt. Therefore, It has no timing belt.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.