0
What else can I help you with?
How do you replace the front turn signal bulb located on a 1996 Pontiac Sunfire GT?
take the wheel well out first then reach in and turn bulb socket
How do you replace the turning signal flasher on a 2004 Pontiac sunfire?
To replace the turning signal flasher on a 2004 Pontiac Sunfire, first, locate the flasher unit, which is typically found under the dashboard near the steering column. Remove the old flasher by pulling it straight out of the socket. Insert the new flasher into the socket, ensuring it is securely in place. Finally, test the turn signals to confirm they are functioning properly.
Change reverse lights on Pontiac Sunfire?
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
How do you wire starter on a Pontiac Sunfire?
In order to wire the starter on a Pontiac Sunfire, you will need a jack, jack stand, socket set, and a torque wrench. You will need to make sure to remove the battery cables from the battery.
What size is the socket for a wheel bearing hub for a 2005 Pontiac sunfire?
I'm fairly certain it's a 30mm.
How do you replace the front turn signal bulb located on a 1997 Pontiac Sunfire GT?
Remove the front inner wheel well splash shield. Grasp the bulb socket and rotate it counter-clockwise to remove it from the lamp. Remove the bulb from the socket. Installation is the reverse of removal.
How do you replace the tail light in a 2000 Pontiac sunfire?
If u have carpet lining in the trunk like I do then when u open the trunk pull the liner behind the bulb u want to replace and the bulb socket should be there...twisting the bulb counter clockwise an eighth of a turn should pull it loose, pull the socket out and replace the bulb then put it back in and follow the previous steps in reverse
Where is th oil filter on a Pontiac sunfire 2005?
It's the plastic cap on the front of the engine. either a 26mm or 30mm socket to open it up.
What size wrench is needed to remove the caliper bolts on the front brakes of a 99 Pontiac sunfire?
You need a 3/8" allan key or hex socket - not a torx
How do you replace a crankshaft sensor on a 1997 2.2 Pontiac sunfire?
To replace the crankshaft sensor on a 1997 Pontiac Sunfire with a 2.2L engine, first disconnect the negative battery cable to ensure safety. Locate the crankshaft position sensor, which is typically found near the bottom of the engine, near the flywheel. Remove any necessary components for better access, then disconnect the wiring harness and unbolt the sensor using the appropriate socket. Install the new sensor by reversing the steps, ensuring a secure connection and proper alignment.
How do you replace a back turn signal light on a 1999 Pontiac Sunfire?
This is pretty direct. From inside the trunk, pull the carpeting away from the tail lamp housing. The bulbs are held in place by twist out/in sockets. Twist the socket and remove it from the housing. Pull the old bulb out and throw away. Put in a new bulb and screw the socket back into place. Turn the ignition on and check the turn signal. Replace the carpeting and you're done! FriPilot
How do you replace the license plate bulb in a 1995 Pontiac Transport?
unbolt lens, remove bulb socket quarter turn
