Depends on what transmission we are talking about... if its the A413 its real simple, the speed sensor is located on the back of the transmission, right about where the passenger side axle goes into the transmission... the sensor is held in with 1 10mm bolt, when removing you will have to wiggle the sensor back and forth because it will be a tight fit because the sensor has an 0 gasket on it.... if its the A604 4speed transmission, then there is 2 speed sensors that are plasic, an input and an output speed sensor, the input is located near the trans dip stick, im not sure where the output is.
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
If you are refering to the vehicle speed sensor (VSS) it is on tranny by where the axles are
the speed sensor senses the speed and tells your transmission when to shift , it also controls your speedometer.
The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
right on the trans they are plug ins one is a speed sensor
It measures the speed of the output gear of the transmission. It is used for shift timing.
It is not adjustable. If the idle speed is not correct, then you have a sensor/actuator/computer issue.
It measures the speed of the transmission input shaft. The transmission computer uses this info for shift timing.
It is located in the passenger side axel housing for the CV joint, on the rear side of the engine compartment.
You need to look on your transmission there should be 2 of them I have A 96 PLYMOUTH VOYAGER 3.0 liter and it has 2 on the transmission on it just match up ur sensors not very hard. sorry best i can do.
The three speed does have a hydraulic governor in the transmission. The four speed does not.
The speed control switch is on the steering wheel.