The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
It measures the speed of the transmission input shaft. The transmission computer uses this info for shift timing.
CODE 23** Indicates that the air temp sensor input is below the minimum acceptable voltage or sensor input is above the acceptable voltage.
The input and output speed sensors are the two wire sensors on the front of the transmission case. The input is closer to the engine.
Input Speed Sensor is on Front of Trans closer to the engine. Output is on the front, farther to the drive side. Both are two wire sensors.
A code 51 on a 1994 Plymouth Voyager typically indicates an issue with the engine's oxygen sensor. This sensor measures the amount of oxygen in the exhaust gases to help the engine control unit adjust the air-fuel mixture for optimal performance. It is recommended to have the oxygen sensor and related components checked and potentially replaced by a qualified mechanic.
yes .. Change filter, then try output and input transmission speed sensors.
the sensor is located in the differential housing on the back of the transmission. (this is the speedomoter sensor, it is in the housing that the pass axle shaft slides into) For the 3.3/3.8L, it is near the bell-housing facing the firewall, as it senses the magnets that are on the torque converter when it spins. (that is the engine speed crank position sensor)
They are the two wire sensors screwed into the front of the transmission case. The input is closer to the engine.
Depends on what transmission we are talking about... if its the A413 its real simple, the speed sensor is located on the back of the transmission, right about where the passenger side axle goes into the transmission... the sensor is held in with 1 10mm bolt, when removing you will have to wiggle the sensor back and forth because it will be a tight fit because the sensor has an 0 gasket on it.... if its the A604 4speed transmission, then there is 2 speed sensors that are plasic, an input and an output speed sensor, the input is located near the trans dip stick, im not sure where the output is.
How do i fix the TPS pedal position sensor in a grand prix pontiac 2004.
Trouble code P0108 means:MAP Sensor Circuit High Input
It can cause it to only have second and reverse gears.