you have to pull the entire speedometer cluster on the back of it you will see little lights turn them until they come out and replace them with new ones
How do you change the power steering belt on a 1996 lexus es300?
1996 ranger does not have speedo cable it is electronic
To replace the speedometer on a 1996 Acura TL, start by disconnecting the negative battery terminal for safety. Remove the dashboard trim and the screws holding the instrument cluster in place. Carefully pull out the cluster and disconnect the wiring harness. Finally, replace the old speedometer with the new one, reconnect everything, and reassemble the dashboard.
I believe it was 1996 that the Explorers started using an electronic speedometer with a vehicle speed sensor ( VSS ) Since then the Explorers have not had a conventional speedometer cable
U HAVE TO REMOVE THE SPEEDOMETER FACE PLATE, AND REMOVE THE SPEEDOMETER AND THERE ARE ALL THE LIGHTS ON THE BACK PART OF THE SPEEDOMETER, PD:BE CAREFULL WHEN REMOVING THE SPEEDOMETER THERE IS A SPPEDO CABLE UNDER NEED U HAVE TO DISCONECT THE CABLE FROM BEHIND.
I don't believe it has one , the Ford Explorers 1996 and newer models don't have a conventional speedometer cable , they have an electronic speedometer and a vehicle speed sensor ( VSS )
the little gear that turns the numbers is broke and the only way to fix is replace the whole speedometer.
To replace the speedometer cable on a 1996 Suzuki Sidekick, first, disconnect the negative battery terminal to ensure safety. Remove the speedometer cluster from the dashboard by unscrewing it and carefully pulling it out. Next, locate the speedometer cable on the back of the cluster, disconnect it, and trace it to the transmission, where it will be attached; unscrew and remove it from there as well. Install the new cable by reversing these steps, ensuring it is securely connected at both ends.
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
Check to see if it has one. You may find that it is all electrical. I did.
To replace the speedometer sensor on a 1996 Buick Skylark, first, ensure the vehicle is parked on a level surface and the ignition is off. Locate the speedometer sensor, which is typically found on the transmission; disconnect the wiring harness and remove the retaining bolt. Then, carefully pull out the old sensor, insert the new one, secure it with the bolt, and reconnect the wiring harness. Finally, test the speedometer by starting the vehicle and checking its functionality.