GM and GMC

How do you replace the starter on a 1988 GMC pickup?

484950

Top Answer
User Avatar
Wiki User
Answered
2006-01-26 15:30:32
2006-01-26 15:30:32

The starter on most GM product is located on the lower passenger side of the engine at the rear of the block held on by two bolts. Disconnect your battery, remove the two bolts, and drop the starter down just far enough to remove the wiring from the starter. ( it helps if you have a block or something to rest the starter on while you remove the wires so there is no tension them.) Simply reverse order.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.

First, remove the negative battery cable. Then remove the wires off of the starter. Then remove the 3 bolts that hold the starter on and work it out around the exhaust.

on top of the starter. you have to disconnect battery then remove starter to replace it

on the engine look around you will find it

1988 to 2000 GMC & Chevrolet pickup truck parts are, for the most part, interchangeable.

Assuming you're referring to a pickup, front of the flywheel housing on the right hand side.

Its the scrol bar to the left of the guages by the head light switch

Remove Distributor,remove drive gear,remove shaft,remove pickup coil.

The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.

No, a GMC pickup has a higher towing capacity, and is just light years better than a Chevrolet. Overall, buy a GMC!

It is screewed into the passenger side of the engine just in front of the starter.

You should probably bring it to a mechanic because it is very difficult to replace the heater core on GMC pickups.

How do you flush the raditor on a 1992 GMC Sonoma Pickup.

Where is the AC sensor located on a 1992 GMC pickup

Sounds like the starter is "dragging" - happens when the bushings are worn. Can be overhauled if you are mechanicaly inclined, otherwise replace the starter.

Your starter solenoid is the ropund part attached to the top of your starter it has the little wire to trigger the starter drive to engage the flexplate and a big battery wire to spin it hope this answers you question

Where is the starter localed on a 02 gmc envoy?

either your starter is bad or u have engine problem idiot

The factory alarm on a GMC Sierra pickup truck can be reset by removing the fuse. Take the fuse out for 10 seconds and replace it. This will reset the alarm.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.