0
Remove positive battery cable. Remove right front wheel. on fender behind wheel well is a flexible cover- remove it. Use 13mm wrench and remove power cable to starter sol. use 5/16 in. wrench to remove signal wire on started sol. remove two bolts holding starter up. jack the motor up from the oil pan and wiggle it out of tight area between bellhousing and frame. With new starter just reverse to install.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the location and how to replace a Starter Solenoid on a 1992 Oldsmobile?
Is there a picture of a Starter Solenoid for a Oldsmobile 1992
Where is the fuel pump located on a 1992 Oldsmobile Bravada?
In the Fuel Tank.
Where is the fuel cutoff switch on a 1992 Oldsmobile bravada?
GM vehicles are not equipped with such a switch.
What solenoid is the starter solenoid on a 1992 oldsmobile 98?
The solenoid is on the starter.
Where is the antifreeze drain plug on a 1992 Oldsmobile bravada?
It should be on the bottom or bottom edge of the radiator.
On a 1992 Oldsmobile Bravada put a new alternator new starter and a new battrey and it wont start all it does is click?
you maybe blew the motor have u tried ur spark plugs distributor cap and all that
How do you replace a starter for a 1992 Saturn SC2 Standard?
how to replace a starter on a 1992 Saturn 4 door car standard
Where is the starter located on a 1992 Cutlass Supreme 3.1 liter?
The 1992 Oldsmobile Cutlass Supreme 3.1 liter engine starter is located on the bottom of the engine near the back. You can follow the positive battery cable directly to the starter.
How do you replace the ignition switch 1992 Oldsmobile 98 regency?
this site is great
How do you locate the fuel filter and how do you replace it on a 1992 Oldsmobile 88?
Behind the driver, under the vehicle.
Where is the fuel pump test port on 1992 Oldsmobile bravada?
If that is throttle body fuel injection, there is no fuel pump test port. You have to fabricate with some fittings and tap into the fuel line at the fuel filter.
How can you replace a starter on a 1992 S10 4.3liter v6 motor - frame is in the way?
you have to remove the crossmember to do this.
