Want this question answered?
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
remove bolts and replace it how do u think
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
Disconnect the - battery cableRaise and support vehicleDisconnect wiring at top of starterRemove starter mounting boltsRemove starter
the bendix gear on the starter is stuck on the flywheel remove starter check bendix gear for wear if worn to bad replace starter
No such thing as a '92 CTS. Model wasn't released until 2003.
== == I had the same problem with my 92 Nissan Stanza XE. Turns out it was the starter. You might need to look into getting a new starter. Also, have someone check your spark plugs, plug wires, and your fuel pump. I say fuel pump because after we fixed the starter problem. The fuel pump went bad. These are great cars, you just have to take a little extra care of them.
The starter on a 1988 Nissan Stanza can be found on the inner side of the engine. It is between the gear box and the engine block.
Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
replace the starter
First make sure it is the starter that is at fault. Then take the neg battery cable loose at the batery. Then take off the wiring then the bolts holding it on and work it out.
90-92 Stanza have 4x114.3 bolt pattern