Auto Parts and Repairs
Pontiac Sunfire
Sunroofs and Moonroofs
DIY Projects

How do you replace the sunroof motor on a 98 Sunfire GT?

484950

Top Answer
User Avatar
Wiki User
2015-07-15 19:09:28
2015-07-15 19:09:28

Working on the sun roof and keeping it from leaking is an art in itself. Take it to a trim shop that works on sun roofs.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You will have to replace the entire motor mount.

User Avatar

the sunroof motor is simple to replace, but may be time consuming. you first have to remove the headliner. take all the trim holding the headliner off to bring the liner down. once you are inside the headliner, remove the two screws holding the sunroof control assembly. Disconnect the wireing harness from the motor. 3 screws hold the motor in place. Before removing the motor, make sure the sunroof is closed and sealed shut. the motor is timed to the position of the sunroof. Do not turn the motor gear under any circumstance. once the motor is out, inspect the drive cables for any visible wear. Installation of a new motor is just the opposite of removal. the new motor should come pre-timed to the "Closed" position.

User Avatar

You have to remove the dashboard, then remove the instrument cluster. On the back of the cluster, you'll find that you can unscrew the bulbs from the back and replace them. I've done it myself on my own 99 Sunfire --- CanadianCynosure

User Avatar

The solenoid/starter motor assembly is installed on the lower part of the engine next to the transmission bellhousing

User Avatar

Answer: Yes, they are one unit, once the unit is removed, you can replace the regulator or the motor.

User Avatar

The solenoid/starter motor assembly is installed on the lower part of the engine next to the transmission bellhousing

User Avatar

It appears so, since The Sunroof Doctor has a replacement motor that will fit 1996- 2002 SL models Sunroof Motor 1997-2002 Saturn SC (2 & 3 Door) 1996-2002 Saturn SL (4 Door) Special! New replacement motor available at this price until our stock is gone. You reuse your original connector or hard wire to your harness $81.55

User Avatar

i just did a engine swap in mine, i used one from a 98 sunfire gt, still the 2.4l. so any 2.4l motor from another sunfire should work, just make sure its from 1997 and up, or if you want to go to the extreme, a chevy cobalt ss motor also fits in as well,

User Avatar

Contact The Sunroof Doctor for assistance. http://www.sunroofdoctor.com/9602saturn.htm

User Avatar

the 98 sunfire haz a 57.2 litre gas tank

User Avatar

it is located under the dash on passenger side of the car an if not their its beside the fire wall on the passenger side as well.

User Avatar

we have a 98 sun-fire that leaked antifreeze for the past 2 mmonths , finally got a mirror to look under everything and found a leak in the water pump. we have to replace it. good luck

User Avatar

replace u joints or motor mount or transmission mount

User Avatar

yes you just replace the manifolds and couple sensors

User Avatar

usually on the driver side door

User Avatar

I have a 98 sunfire with the 2.4L and it is getting about 35m/gal on the hwy.

User Avatar

On a 98 Pontiac Sunfire, the red color of wire goes on the terminal marked "B" on the starter. This terminal is located close to the battery of the vehicle.

User Avatar

If the blower works on some speeds and not on others, you may not need a motor. Instead, you may only need a new blower motor resistor.

User Avatar

This should help you out; http://consumerguideauto.howstuffworks.com/1995-to-2005-pontiac-sunfire-6.htm FriPilot

User Avatar

Have a look at this web site; http://consumerguideauto.howstuffworks.com/1995-to-2005-pontiac-sunfire-6.htm FriPilot


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.