Thermostats
Toyota Camry
Volvo 850
Ford Vans

How do you replace the thermostat located on a 1993 Ford van V8?

414243

Top Answer
User Avatar
Wiki User
2006-06-05 02:53:00
2006-06-05 02:53:00

The best way is to follow thw the top radiator hose there will be the housing with two bolts spray with w-d 40 or similar be very carful not to break bolts or you will have to dill it and put in a heli coil ,put in a 195 degree or same as you had in with new gasket ,make sure thermostat stay in groove in housing while installing

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The thermostat is at tje engine end of the upper rad hose, When replacing it make sure the spring goes toward the engine.

User Avatar

The thermostat on a 1993 Ford e 350 7.3 diesel is located on the side of the engine. The thermostat can be found by following the upper radiator hose.

User Avatar

follow the top radiator hose to the engine, remove it then remove the thermostat housing, remove the thermostat and replace it

User Avatar

where is location of thermostat in ford aerostar van, 1993

User Avatar

How do I replace thermostat on 97 Ford van

User Avatar

Replace thermostat on 91 ford eacort

User Avatar

Remove the top radiator hose. The thermostat is located under the hose inlet on the engine. Remove the inlet to replace the thermostat.

User Avatar

On a 1993 Ford F-150 : Follow the top radiator hose from the radiator . Where it connects to the engine is the engine cooling thermostat

User Avatar

where is the thermostat located on a 1989 ford tempo

User Avatar

follow the upper radiator hose other end is connected to thermostat housing

User Avatar

i had a 93 t-bird & the thermostat is located on the front of the intake manifold. just follow your top radiator hose back to it

User Avatar

Follow the top radiator hose back to the engine. This is where the thermostat is. Remove the 2 bolts and there it is.

User Avatar

follow the coolant hose that goes under the distributor.

User Avatar

It is in the housing at the engine end of the upper rad hose. When replacing it make sure the spring on the thermostat is toward the engine.

User Avatar

locate the top radiator hose and follow it to the motor, unbolt the housing it is connected to and remove the old thermostat replace it and put it back together

User Avatar

locate the top radiator hose and follow it to the motor, unbolt the housing it is connected to and remove the old thermostat replace it and put it back together

User Avatar

locate the top radiator hose and follow it to the motor, unbolt the housing it is connected to and remove the old thermostat replace it and put it back together

User Avatar

To replace a thermostat on a 2000 Ford F-250 V10, drain the radiator. Locate the thermostat on the top hose assembly and remove the screw. Replace the thermostat and refill the radiator.

User Avatar

The thermostat is located in the water neck where the top radiator hose goes on. Its mounted in an O-ring, just pop it out with a screwdriver and replace it.

User Avatar

According to Haynes Repair Manual #61042 for the years 1993 thur 2001 fot the Mazda 626 & MX-6 Ford Probe the engine thermostat is located on the driver's side of the engine compartment under the air breather. It is necessary to disconnect the ram-air hose & remove the air-filter compartment to reach the thermostat. The thermostat is held in place by two bolts & an "O" ring gasket. I had to replace mine & is took a "little while" to remove everything to get to the thermostat, replace the thermostat & then replace everything back in place as it was before.

User Avatar

follow the upper radiator hose from the radiator to the engine this is where youwill find the thermostat housing. remove ther housing and you'll be looking at the thermostat. it is realy easy


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.