Remove the negative battery cable being careful to put it out of the way from any contact.
You may need an impact screwdriver to remove the "old" TPS due to the fact that Ford has been known to use "locktite" on this particular part. Other than that it should be a pretty simple operation. After removal of the "old" TPS you should note the direction of rotation for the Throttle Body plate shaft when throttle is being engaged. Then when installing the "new" TPS rotate it a bit in the SAME direction the shaft travels then ease it back and line up the holes. You should feel some resistance on the spring as you do this.
The two small tabs on the TPS should both be ahead of the nub on the TB plate shaft.
Then just tighten it back up, re-attach the negative battery cable and your good to go.
The throttle position sensor is mounted on the side of the throttle body
how to replace the throttle position sensor on a 97 nissan altama
How to replace throttle sensor kia spectra 2003
The throttle position sensor is mounted on the side of the throttle body
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
you dont!
There is no adjustment, they are electronic. You just replace them.It senses the position of the throttle and sends the information to the computer.
It is a part of the throttle body. You have to replace the throttle body if faulty.
The throttle position sensor, TPS should be in about the same position as it was in earlier models - so the "Related Question" below should also be helpful.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
The throttle position sensor is on the drivers side of the throttle body. It is right in the middle with a connector hooked to it and two torx head screws holding it in.
The throttle position sensor is in the throttle body.