The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
you can't you have to replace it!
how do you replace the headlight switch on a 1993 cutlas ceria*
Yes, you do.
The cost to repair your 1997 Oldsmobile Cutlass sunroof is dependent upon the condition of the sunroof. It will cost approximately $700 to completely replace the sunroof.
Simple, just replace your alternator..
take the complete headlight assembly loose or out to get to the bulb.
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
Best left to a pro unless you want to decapitate yourself.
you have to turn the pistons at the same time you push the pistons in
you will have to drop your gas tank its inside the tank drive safe
First, remove the thermostat housing. Then grab the thermostat by hand and remove it.
What size engine? 3.1 or 3100? yes there is a difference. email@example.com
What year?? This makes a big difference, especially with the early 90's on up.
Replacing a thermostat on a 1999 Oldsmobile Cutlass is very easy to do. First you will find the thermostat by following the upper radiator hose. It is under the exhaust crossover. The thermostat has two 13 mm bolts holding it in place. Take the bolts off to remove the thermostat and replace with a new one.
water pump has some (2) pins into the block...it needs to be pryed stright off.
Replace headlight switch- dimming rheostat may be loose
how do you replace a starter on a 1998 cutlass
You can unlock your Oldsmobile Cutlass antitheft stereo by removing the stereo fuse. Keep the fuse out for 30 seconds and replace it to its original position.
under carrage of vehicle, just fwd of fuel tank. easy to find & replace
Back seat has to come out and the rear package tray too and then you can get to the bolts that hold the speakers in.
Remove the power steering hose. Remove the power steering belt. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump on your 1985 Oldsmobile Cutlass.
Begin by removing the serpentine belt from your Oldsmobile Cutlass. Remove the tensioner pulley retaining bolt. The retaining bolt will be in the center of the pulley. Reverse the process to install your new belt tensioner.
You have to remove the passenger side wheel, and inner fenders, then the drive axle and heat shield, then you can get at it. From underneath.....sorry.
It's less than 2 hours work - depends on local labour cost.