Buick LeSabre

How do you replace the water pump on a 1987 Buick Lesabre?

131415

Top Answer
User Avatar
Wiki User
2014-10-07 02:13:51
2014-10-07 02:13:51

Drain the radiator. Remove the LeSabre's top radiator hose. Unbolt the engine water inlet and remove to reach the thermostat. Pull the thermostat out and slide in the new one. Reinstall the inlet and hose before filling the system with new coolant.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the thermostat located on a 1987 Buick LeSabre?

User Avatar

where is the relay located on a 87 lesabre

User Avatar

I have a 1990 lesabre and im 90% sure its a 16 gal.

User Avatar

depends where the leak is, and how bad it is.

User Avatar

The lock assembly is located in the center of the door panel of 1987 Buick LeSabre. Use of a Slim Jim is only legal for locksmiths and law enforcement officers.

User Avatar

There are 2 bolts that hold it to the rear of the engine.

User Avatar

It is with all of the relays in the center of the firewall under the hood.

User Avatar

You need a ball joint press to do that job. Remove old ball joint with sledge hammer and press new on into control arm.

User Avatar

Fuse panel. Open and read your owner's manual.

User Avatar

All of them, if you want a blazing fast car, go with a 1987 Buick LeSabre, or a 1994 Toyota Rav4

User Avatar

the filter is located right under the driverside just in front of the rear wheel

User Avatar

it is on the passenger side of the engine compartment, and is part of the big silver accumilator.

User Avatar

Try looking for a Chilton's repair manual on Amazon or eBay. They're dirt cheap now.

User Avatar

Get a manual on your car from the parts store or from AUTOBOOKSONLINE.COM. This is not a job for the backyard mechanic as you have to hold the engine while the trans is pulled.

User Avatar

Mine is 1990 LeSabre,is there any difference too rule? Too take the dood panel off drivers side front!? Too get too window/track?

User Avatar

Unhook your battery, locate your starter........ which should be behind A/C compressor there are 4 bolts, two in the front and two behind the starter.

User Avatar

Before you go replacing the timing chain you need to check and be sure it has NOT bent some valves. If that is the case then you are looking at a Hugh repair bill. Go to an auto parts store and purchase a Haynes Manual. It should be a great help.

User Avatar

How do you replace the water pump on a 1988 Cadillac Seville?

User Avatar

You can purchase a Hyanes repair maunal for about 10 dollars. It will have pictures and step by step instructions on how to repair your brakes.

User Avatar

Theres a small opening in what appears to be the airconditioning duct work middle of dash under ash tray you have to practically get on the floor on your back to see it.

User Avatar

I don't know what you are calling a sensor box. If you are refering to the computer, go to auto zone and have the codes read free. GoodluckJoe


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.