Chevy Lumina

How do you replace the water pump on a 1992 Chevy Lumina 3.1L?

8910

Top Answer
User Avatar
Wiki User
2014-10-07 02:14:07
2014-10-07 02:14:07

Remove the belt from your 1992 Chevy Lumina water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to install your water pump.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you convert the ac in a 1992 Chevy lumina

User Avatar

Hopefully you mean a 1992 Lumina, and yes, most starters are standard.

User Avatar

there is no alternator on the 1992 Lumina its all electric, so there is no need for one.

User Avatar

The Chevy lumina does not have an inertia switch.

User Avatar

It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.

User Avatar

Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

Where do I find a fuse panel diagram for a 1992 chevy luman

User Avatar

Yes, there is a windshield wiper relay on a 1992 Chevy Lumina. The windshield wiper relay is located in the underhood fuse panel.

User Avatar

Remove the belt from your 1992 Chevy Lumina power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.

User Avatar

Just go to Google and search for '1992 Chevy lumina wiring harness' up will pop 20 or a 1000 places willing to sell you one.

User Avatar

how do you replace a CV joint on a 1992 Chevy pickup?

User Avatar

water in the fuel bad spark plugs bad plug wires bad coil

User Avatar

Remove the cylinder head from your 1992 Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.

User Avatar

Yes, he did. Dale Sr. drove an all black #3 Chevy Lumina during the 1992 Winston Cup season.

User Avatar

My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.

User Avatar

Your 1992 Chevy Lumina will run with a bad 02 sensor. The engine will seem to be sluggish and the fuel mileage will go down.

User Avatar

The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.

User Avatar

You're not gonna find a strainer on that car.

User Avatar

That year model did not use are have a crank sensor.

User Avatar

dont laugh but if it is like the one i wporked on recently you must pull motor mounts and pull engine up slightly to get to it then reverse not a do it yourself job if you have no mechanical exsperience


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.