Chrysler LeBaron

How do you replace the water pump on a 1994 Chrysler LeBaron 3.0L V6?

616263

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 20:06:31
2015-07-15 20:06:31

the water pump is locate in back of the motor bracket on the left side of the engine it take about 4 hours to remove it

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


RockAuto.com has auto parts and body parts for the 1994 Chrysler LeBaron at discounted and wholesaler closeout prices.

Lower radiator side of the engine.

4 cyl driven by the alternator belt. 6 cyl, driven by the timing belt.

Chrysler doesn't use inertia switches. The fuel system is computer controlled with relays

It is screwed into the exhaust manifold on the back of the engine.

It is located about 1/2 way up the right underside of the vehicle. The same on a 1997 Chrysler Concorde How do i have to replace the filter Chrysler Concorde 1994? How do i have to replace the filter of Chrysler Concorde 1994?

In the exhaust pipe before the catalytic converter, which is right behind the engine

Your question is confusing because it sounds like you want to remove the whole car.

Always use ATF3 or ATF4. Any other type of fluid in a Lebaron transmission will shorten the lifespan of the transmission.

replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo 6 cylinder

Chrysler does not use inertia or shut off switches. The fuel system is computer controlled with relays.

A cog and gear attached to the transmission which turns a worm driver attached to the tach

a convertible weighs 3010 lbs with no one in it, a coupe weighs 2863 with no one in it

should do.. Check the VIN Number, the 1993 and 1994 can be replaced without restriction, but if the production date is earlier, change the newer TCM module, too (even if it works with the older one, but the newer are better and your car will use less petrol

The water pump is located behind the timing belt cover. It is driven by the timing belt. If you decide to replace it, replace the belt and idler pullys at the same time.

It is on the inside of the fuse panel lid located near the hood release lever.

you pull the two latches above the sun visors and then there is a button on the center console

remove back up tire in back right behind seat

look on the inside of cover or lid .It should have diagram .If not ,there is a diagram in owner's manaul

Unhook the negative cable and wait ten minutes, the computer is reset.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.