Want this question answered?
Yes. Check the fuse/relay center under the hood.
73 chevy c-10 350 v8 need fuse box wiring harness color coded diagram
Under the dash on the driver side. Follow the wiring harness back from the fuse box. It's about six inches back and is taped on to the wiring harness.
check wiring from battery to wiring harness to fuse (check fuse also) to harness to brake light. Check ground, too
Yes. Bad wiring can make any fuse blow
It is not possible to Jump Start your Harley using the battery tender wiring harness. The battery tender wiring harness has a 3amp inline fuse that will blow if you attempt to do this.
The airbags on a 2002 Chevy Cavalier are disconnected by removing the positive battery cable and pulling the airbag fuse. The wiring harness to the airbag can then be pulled to allow the airbags to be taken out.
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
Check for recalls first then I would estimate either an overload on the circuit, bad wiring harness between particular fuse and the component it powers, or a loose wire.
Chevy did not use a reset / INERTIA switch on there trucks. Chevy did have a problem with the wiring harness at the top of the fuel tank / connector. You may also want to check the fuel pump relay and fuse.
Probably a bad fuel pump. Disconnect the wiring harness at the fuel pump and put in a new fuse. If it doesn't blow and you have 12 volts at the pump with the key on, replace the pump. If your fuse still blows, you have a short in the wiring somewhere.
Yes.