0
What else can I help you with?
How do you replace the left rear brake light bulb on a 1998 Acura Integra hatchback?
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
What is the firing order for a 1989 Acura Integra?
1342
What is the Wattage of a stock stereo in a 1989 Acura Integra?
The wattage of your stock stereo in your 1989 Acura Integra is 75 watts. There was anÊoption for a larger stereo output of up to 200 watts.
How do you set the ignition timing on a 1989 Acura Integra?
Ignition timing is set on a 1989 Acura Integra by setting the distributor to the appropriate angle. When set at the factory recommended angle the car will turn over with no problems.
What is the firing order of 1989 Acura Integra?
1-3-4-2
How Much transmission fluid is in a 1989 Acura Integra with an automatic transmission?
8lts i think
Where is the speed sensor located for a 1989 integra?
The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.
How do you remove the stock stereo of a 1989 Acura Integra?
You have to unscrew the center console and work your way up.
How do you replace water pump on 1989 vigor?
there was no 1989 vigor..acura
Where can you find the fuse diagram on your 1989 Acura Integra?
its on the fuse box door. if you lost the door maybe you can get one at a junkyard or your friendly acura dealer might help
You lost your key to your 1989 Acura Integra what can you do?
If it is the original ignition, you should be able to get a key from the dealer with the V.I.N. The number on the dash.
How do you replace a head gasket on a 1989 Acura Integra LS?
To replace the head gasket on a 1989 Acura Integra LS, first disconnect the battery and drain the engine coolant. Remove the intake and exhaust manifolds, timing belt, and cylinder head bolts in the correct sequence to avoid damage. Clean the mating surfaces, install a new gasket, and reassemble the components in reverse order, ensuring proper torque specifications for the head bolts. Finally, refill the coolant, reconnect the battery, and start the engine to check for leaks.
