Of course you Can
The Pelvic Girdle supports the trunk of the body..
You get to it from the trunk. Lift up the carpet, and locate access panel in front pass side of trunk.
a trunk
there are metal clips on each end you need a small flat head screwdriver to pop them out and the lift supports will slide right off dont lose the clips tho you might need them for the new ones http://www.hometeammotorsports.org/
Strength is the skill in which the trunk lift test is aimed at.
The trunk lift is a procedure that is used to measure trunk extensor strength and flexibility. The objective of a trunk lift is to lie face-down on the floor and lift the upper body using only the muscles in one's back. This position is then held and measured.
If you mean fuel pump module. You get to it from the trunk. lift out the carpet, their is an access panel with about 5 8mm bolts, front of trunk, pass side. You have have to crawl all the way into the trunk to get it out. Make sure the hood supports are stable, so you don't lock your self in the trunk !
There are small metal clips at each end of the supports that hold them onto a ball end stud. Take a small screwdriver and pry the metal clips out of the slots that they fit into. {you don't have to take them all the way off} They shoud then just slide off of the stud. Replace with the new lift supports and snap clips into slot.
open the trunk look on the lift and the right side in the trunk at the back there a shock tower there a nut to remove. under the rear wheels there a nut remove it .
The axis supports the weight of the head.
Stretches