answersLogoWhite

0


Best Answer

Ya jack it up,remove the the wheel,under the hood,remove the two 18 mm nuts from the control arm near the strut,remove the cotter pin and nut from the upper ball joint and smackit with a hammer,and install new control arm with ball joint.

I saved a sht load doing it myself.and it only took about an hour.dont get raped by those aholes

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace upper ball joint on Honda Accord?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace an upper ball joint on a 1994 Honda accord ex?

You have to take the control arm and ball joint to a shop and have them pressed together, otherwise it is easier to buy the new control arm with the ball joint already in it.


How do fix a squeaky front end suspension on the drive side of a 1994 Honda Accord?

The squeak is most likely coming from your upper or lower ball joints. Replace your worn ball joint(s) and that'll fix your problem.


Where is the relay switch for cooling fan at on a 1995 Honda Accord?

I have a 1992 Honda Accord and have recently had to replace my fan relay. It was located under the hood at the top/left. Hope that helps. I own a 95 Honda Accord LX, the relay switch for my cooling fan is under the hood in with my fuses on the left upper side. ;-)


How do you change the upper left ball joint on a 1992 Honda Accord EX?

the upper balljoints are part of the control arms. it is easier to replace the whole arm with the balljoint already attached. It is only about a half hour job if you take it to a mechanic, but you should get an alignment afterwards, as with all front end work.


How do you take out upper ball joint from the upper arm Honda civic 1989?

what i know you can't take that ball joint to upper control arm but if you buy the upper control arm the ball joint comes with it.


How do you replace the thermostat located on a 1992 Honda Accord?

follow lower hose to rear of engine. rember to bleed. bleeder located on the upper radiator hose housing.


Where is a coolant temperature sending unit on a Honda Accord?

On a Honda Accord the coolant temperature sending unit is on the passenger side of the upper engine. It is next to the cylinder head.


How do you replace upper ball joint on 2002 sierra?

Part Of Upper Control Arm


Where is the thermostat located in a 1992 Honda Accord lx?

The thermostat in a 1992 Honda accord lx is located in housing that can be found when you follow the upper radiator hose back and finding where it connects to the engine.


How do you Adjust camber on 1989 Honda Prelude?

you can slot the holes where the upper ball joint bolts to upper control arm.


How much will it cost to replace timing belt and water pump on a 2003 Honda Accord?

For most Hondas, it ran run you anywhere from $400 to $700 USD depending where you go. A Honda dealership will be closer to the upper end in cost, but they usually guarantee their work.


Where is the thermostat located on a 1985 Honda Accord?

Look in a removable housing at the engine end of the upper radiator hose