Ball Joint Replacement:
I used the rental tool to press out the old ball joint and press in the new one. When pressing out the old ball joint the key is to properly set up the press, tighten the screw on the press, then give the screw a few good solid blows to shock the old ball joint. Once I did this the old ball joint pressed out almost effortlessly. Installation of the new ball joint was a breeze. The only comment is be extremely careful not to damage the axle boot seals. Have wire on hand to tie the spindle assembly and axle for support to prevent damage to the brake hoses and ABS system.
How to change upper and lower ball joints on a 1997 ford explorer all wheel drive?
The ball joints are bolt on parts that don't require any special tools to replace.
need video on how to put upper ball joints in a 97 merc mountinare
It is not cost-effective to attempt to replace just the CV joints. Rebuilt CV shafts are available for as little as $60.
how do u replace the lower ball joint on a 1997 ford mustang
near the front wheels on the upper and lower control arms
1 - simplest and cheapest method- replace the axle 2- replace the CV joints and boots 3- lots of unnecessary work, very expensive - check the joints and replace as needed, replace boots
Should be on the upper end of brake pedal
I corrected the problem on my 1998 Dodge Ram 1500 by replacing the upper and lower ball joints.
Replace the radiator
Remove the 2 bolts at the thermostat housing. The upper hose goes to the thermostat housing.
Head gaskets do not go bad on these. You need to replace the plastic upper intake manifold as it is leaking coolant into the combustion chamber. Common problem for this engine.