0
Add your answer:
Earn +20 pts
Is it possible to replace the water pump seals on a 1989 Jeep Wrangler or do you have to replace the entire water pump?
Replace water pump and gasket
How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
How do you replace spark plugs in a 1989 Cherokee?
How to replace spark plugs in a 1989 jeep cherokee?
Do you have to drop the transmission to replace seals on a 90 Jeep Wrangler?
Transmission seals? front yes, rear no. Engine seals, yes.
How do you replace the valve cover gasket on a 2004 Jeep Liberty?
The valve cover gasket, on a 2004 Jeep liberty, can be found by removing the valve cover. Peel the gasket off of the head and replace with a new gasket.
Where is the EGR valve located on a 1989 Jeep Cherokee?
on a 4.0 it should be under the exhaust manifold
How do you replace the valve cover gaskets on a 2003 Jeep Liberty?
To replace the valve cover gaskets on a 2003 Jeep Liberty, the valve cover is removed. The old gasket is then removed from both the valve cover and the manifold (old gasket will come off in pieces on both sides). Then spread the sealant on the manifold, place the new gasket on, then put sealant on top of the gasket and replace the valve cover and bolt down.
Is the 1989 jeep temp sensor above the intake or below the intake?
Above, it is behind the valve cover.
Where is the EGR valve located on a 1989 Jeep Wrangler 4.2?
Looking at the front of the motor, the egr valve is located on the right lower side of the carburetor.
How do you replace the choke 1994 Jeep Cherokee Sport?
doesn't have a choke , but has an enrichener valve , remove the bolts that hold the valve ,take it out unplug & replace ,can be found near throttle body .
Where is the PCV valve in a 1996 jeep wrangler and how do you replace it?
PCV valve is on top of one of your valve covers and it should just pull out there should be a big rubber line on it
Why does 1989 jeep change up at high revs?
On the front side of the throttle body on the left side is a air valve with 2 tork screws. Remove it and clean the carbon out with gumout spray or replace it. That is the fast idle valve. that is why when you start your engine it revs and idles down.
