Want this question answered?
P0443 - EVAP control system CANISTER PURGE VALVE CIRCUIT MALFUNCTION - VPWR circuit open - Evap canister purge valve circuit shorted to ground - damaged EVAP canister purge valve - EVAP canister purge valve circuit open - EVAP canister purge valve circuit shorted to VPWR - damaged PCM
On a 2001 Ford Explorer Sport Trac : I believe the PCV valve is on the REAR of the drivers side engine valve cover ( between the valve cover and the firewall )
The oil drain valve on a 2000 Ford Explorer Sport is located near the rear of the oil pan. The radiator drain petcock is located at the bottom the radiator.
On the 1998 Lumina LTV you will find the Evaporative Canister under the car, between the gas tank and spare tire well that protrudes from the bottom of the trunk. Easy to replace. Costs between $65 and $120. If any of the lines are cracked you should replace them with new ones if you can. If you have already replaced the Evaporative Canister Purge Valve located on the top front of the engine, next to the valve cover, and you are still getting an OBD code P1441 the charcoal in the canister may be breaking down and getting sucked into your new purge valve. It is a good practice to replace both the purge valve and the canister at the same time if you can afford to. Paul
The canister vent valve is located near the fuel tank. The canister purge valve is located on the engine.
Do you mean P0433 ? - Evap Canister Purge Control Solenoid or Valve Faulty or Faulty Circuit
where is the canister purge valve located on a 03 chevy venture
On the 1998 Ford Explorer Sport with 4.6L V8 the positive crankcase ventilation (PCV) will be located on the driver's side of the vehicle. On top of the front-left engine valve cover will be a grommet and hose assembly. In between the grommet and hose, and attached to the valve cover is the PCV valve.
drop the spare tire,under neath the spare tire the canister is right there,undo 3 12mm bolts and the canister will come down,then theres 2 10mm that hold the vent control valve in there undo the vapor lines and the vent valve connector and reinstall new one
should b on top of the manifold....it has a vacume line that runs to it,its a small canister
also referred to as the Vapor Canister Purge Valve and is in\on the charcoal evaporator canister. its under the floor above the spare tire location, locate the charcoal canister on the front of the gas tank and trace the vent line to the vent valve.
On my 2000 Ford Explorer Sport 5-speed manual transmission 4.0L V6 OHV, the PVC valve is located as follows: Standing in the front of the vehicle looking at the right side of the engine on the top of the valve cover. It was stuck down in the valve cover with a tube running from it to the intake manifold. Hope this helps you out!!