Want this question answered?
There is only one windshield washer reservoir in a 05 tribute. The one reservoir is shared between the front and the back. That reservoir is in the engine bay in the passenger side front corner.
No where except maybe in the windshield washer reservoir if you live in a warm zone that doesn't go below freezing.
The rear window washer system shares the same reservoir with the front window washer system. This shared reservoir is located just behind the right side headlight. There are just two separate pumps mounted in the bottom portion of the same reservoir.
there is . make sure the resivoir is filled up
If it is clogged use a fine sewing needle (needles come in different thicknesses)to open the hole..use washer to force clog out.. also try a cotton ball soaked with ammonia to soften the clog..
passenger side front by windshied washer reservoir
The fuse located inside (driver's side) #13 is responsible for it.
It is mounted at the windshield washer tank outlet (on the bottom of the tank). You need to remove the tank from its engine compartment mounting to gain access.
the fuse is located inside the passenger compartment in the fuse box close to the hood release latch-20 amps
The reservoir is located on the master cylinder in a Mazda 626. To add fluid, simply remove the reservoir cap and pour fluid in.
It is in front, on the passenger side, at the bottom of the windshield washer tank. Your acces to is from the front passenger wheel under the plastic cover thatis all around the wheel. Unclip thefake-plastic screws, mostly the one close to the tank. Once you've locate the reservoir and the pump,unplug the electrical harness and the small pipe and then pull it by the upper side with a flat screwdriverand it'll come easy...It's just a snap-on pump with a rubber piece around that make it thight around the plastic pump.
hey== just take off the frame, slide it out and replace its simlpy easy! sincerly, hnrvjeyshtl