answersLogoWhite

0

why is it after I hooked up the linkage for my wipers the wipers stay in the upright position after I turn them off.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Why does only one wiper work on my 2001 buick century?

The non working wiper on the 2001 Century most likely has a broken wiper linkage. The linkage can be checked by removing the vehicles cowling.


How do you replace wiper crank arm for 2001 Chevrolet impala?

how do you replace wiper crank arm 2001 chevrolet impala?


How do you replace a water pump for a 2001 Ford Ranger?

how to replace water pump on 2001 ford ranger


2001 vw jetta wiper linkage repair?

http://forums.vwvortex.com/zerothread?id=3788513


One wiper works and one doesnt work on 2001 doge caravan?

Disconnected or broken control linkage? Bad wiper transmission?


The passenger side windshield wiper on your 2001 Honda passport stopped working how do you fix it?

Check for broken or disconnected linkage Bad wiper transmission?


Where is shift linkage located on 2001 Ford Ranger?

Middle corner near to fuel pipe....


How do you change the wiper blade motor in a 2001 Jetta?

how do you replace a wiper motor in a 2000 jetta?


How do you change wiper transmission assembly Chevy Tracker 1998?

how to replace wiper transmission assembly on a 2001 tracker


Why does driver side wiper work and the passenger side wiper doesn't on 2001 F150?

There'll be a linkage which connects the two wipers together... that may have come loose or gotten broken otherwise.


How do you replace the shift linkage on a 2001 Chevy Cavalier with auto transmission?

The 2001 Chevy Cavalier automatic transmission shift linkage is held in place with a swivel nut on each end of the shift linkage. Turn the swivel nuts to the left and the shifting linkage will come off. Reverse the process to install your new shift linkage.


How do you replace the neutral safety switch on a 2001 Dodge Dakota?

The neutral safety switch is located on the side of the transmission at the linkage connection. Unhook the wiring connector, Disconnect the linkage, then unbolt the switch to replace it.