I don't know if this will work, BUT it's instructions I found on an eBay auction:
PROGRAMMING2003 2004 2005 2006 2007 Pontiac VIBE+++ Do this in order to replace or add a transmitter or when your system malfunctions
1. Start with the key out of the ignition. Open the driver door (all other doors are closed). Driver door is unlocked (other doors don't matter).
2. Perform these steps within 5 seconds a. Insert the key into the ignition (don't turn it) Pull key out b. Insert the key into the ignition (don't turn it) Pull key out
3. Perform these steps within 40 seconds a. Close, then open the drivers door. b. Close, then open the drivers door. c. Insert the key into the ignition (don't turn it) and pull it out.
4. Perform these steps within 40 seconds a. Close, then open the drivers door. b. Close, then open the drivers door. c. Insert the key into the ignition and leave in the ignition. d. Close the drivers door Turn the ignition to ON (as far as you can go without cranking the engine), then back to off . e. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds a. Press the lock and unlock buttons on the transmitter simultaneously for 1.5 seconds b. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock then unlock once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b as the remote was not accepted.
7. Open drivers door
Good Luck
This is in the manual, but will repeat to answer the question. First take of the cover that reveals the key hole. On the drivers door handle there is a cover with a slot on the bottom to remove the cover. Use a flat blade screw driver to remove it. On the remote depress the bottom to remove the manual key. On the remote hit the unlock button. Then unlock the door with the manual key. The alarm will sound. Place the blade in the ignition and the remote blade should be reprogramed.
No
what answer!
your key fob can only be programed by the local gm dealer.
You'll probably need to have this done at a dealership.
With the dealers scan tool.
the bastards at the dealership have to do it...had it done, not cheap.
Take it to your dealership they would be the one to help you with that.
is there a video on how to change the starter for a 2003 vibe
You normally do not have to reprogram the key when you replace the battery. If you do you will have to contact your VW dealer.
you will need to go to a main dealer to get it reprogram it
2006 jetta tdi both key remote not working
The 1.8 liter four cylinder in a 2003 Pontiac Vibe has a timing CHAIN