1. Start with key out of ignition, drivers door is open all others closed and
drivers door is unlocked. 2. Insert key into the ignition (Do NOT Turn) and Pull key out. 3. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Close, then open drivers door. 4. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Do NOT Start) then back to OFF. X2
D. Remove the key from the ignition. 5. Within 3 seconds the power door locks should cycle automatically indicating successful
entry into programming mode. Return to step 1 if the locks do not cycle at this point. 6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
B. Immediately after letting go of the lock and unlock buttons, press the lock button by
itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once
indicating successful programming. If the door locks do not cycle, or cycle twice.
repeat steps A and B in step 6 as your remote has not been accepted.
C. Repeat steps A and B in step 6 for each new remote.7. Close drivers door.
how or where can i purchase a new auto mate remote contrl for my 2001 toyota sequoia
EBay. Or I have a couple of extra ones
Press reset?
Take it to the dealer
reprogram 98 ford expedition with viper 600 alarm
To reprogram the alarm remote for a Porsche boxster, one must put the key into the ignition and turn to position 1, first click. After, you must then turn the ignition off and leave the key in for approximately 15 seconds. The last step is to start the car; this will successfully reprogram the remote.
replace the remote
It has something to do with your alarm 'accentuator' - contact Toyota about this since it might be a recalled item.
How do you replace the computer on a 2000 montero sport
-I was to;d that only the dealer can do it.They need to send to Germany for a new code and then they reprogram the remote.
Put key in ignition and then turn on/off 3 times.
the alarm must of been faulty so i think you should get it checked because that is not really normal hope this helps