A person can reset the maintenance required light on a 2004 Toyota Sienna by holding down the odometer trip button. A series of zeroes will appear, which indicates that the light has been reset.
How do you reset maint read light on 2010 corolla
The answer is in the manual.
The maintenance required light requires a scan tool to be reset.
read your owners manual
Just found out that it must be reset at the dealership with a diagnostic computer
With the ignition off, push and hold the trip reset button. While holding the trip reset button turn on the ignition and look for five dotted lines. When the five dotted lines disappear you can release the trip button and the maint reqd indicator will clear.
Unplug or replace maint. timer
MAINT REQD on means its time to replace your engine oil. The indicator lamp stays on until it is reset. To reset this reminder: While the ignition switch is on, but the engine is not running, move the trip selector to ODO. Push and hold down the trip selector push knob. Turn off the ignition switch, then turn on the switch. The reset will go through 000000.0 then ------, -----, ----, ---, --, -. once it runs through, release the trip selector knob. The MAINT REQD lamp goes out.
Which alarm? If you are talking about the Maint. alarm that is done by holding down the milage reset button on the dash and then putting the key in the ignition and turning it until the warning lights come on, then wait until the Maint light goes out about 15 seconds, then turn off the ignition and then release the the milage reset button.
clear maint code from 2001 slk 320
Maint. required light want reset.
With the key in the off position, press and hold the mileage reset button. Continue to hold the button in, and turn the key into the accessory position. Hold button in until 'Maint Req'd' light goes out (about 5-10 seconds).