There are 9999 possible combinations for the lock once you forget the combination. However, it is possible to get it open by fully locking it and then slowly spinning each wheel until it gives. Not everyone is good at this, but some people can do it quickly.
You need to install a new operating system if you tried to reset your Gateway laptop but get stacked on a screen that says setup is starting services and it has been running forever and you can't get past it.
The most common cause of the pointer on a laptop getting stuck and not being visible is malware. Another cause is overheating.
The heater control valve is used to shut off hot coolant from entering the core when the heater is in the off position. A heater control valve can be actuated by either a vacuum line or a cable from the vacuum heater control valve to the heater core. This hose should be warm; if not the heater control valve is stuck and needs to be replaced
Revisit your outline and use it to find a solution
Well oviously.......you might get it stuck in the machines ever seen Saw the Movie? well anyways a girl at our school got her hair stuck in a machine and it ripped half the skin on her head off and her heair was blonde. but after it have been in the machine it went ginger with blood. x
My brinks locked in the open position. What do I need to do to get it fixed
Try disconnecting your battery and reconnecting it this should reset the door.
To reset the airmatic on a 2000 S500, remove the relay of the airmatic pump. It is in a slot O on the passenger side. It is most likely to be stuck on the on position. Then slip it back in.
You can detailed instructions on how to reset your wipers on youtube.com/watch?v=KFBLtlnkpuI
Reset the light by cycling the key from the on position to the off position and back to the on position. If, however, the sensor still reports a low coolant level your light will come back on immediately. It is a good idea to first verify that the coolant tank is full and then gently tap the bottle with a screwdriver handle or similar object to free up stuck sensor. If the sensor is badly stuck it may be necessary to replace the tank. It is very common for the sensor to become stuck after coolant contamination by oil or from normal supplemental sealer additive being incorrectly installed.
Put it in neutral if it wont shift at all something is broke internally.It does not have a reset button and no proceedure to be reset...sorry
take out the battery or turn it off and reset it
turn key to on position (do not start engine)press and hold both reset and trip buttons for about three seconds instrement cluster will run self diagnosis then all should reset.
There is no way to reset the light. If the light is on, then either the coolant is low, the float is stuck or the sensor is bad.
i have a 2009 G6 Pontiac that is stuck in the snow it says engine disbaled ...someone told me that there is a reset switch
You can not close any door if the locking mechanism is stuck in the locked position. You must first get the mechanics to unlock.
Try disconnecting the power and then reconnect to reset the unit. Look for a reset button on the unit.