if you have a newer car with an electronic gauge cluster with mpg, oil life, and things of that nature you can reset it through there if you know the codes....if not....gotta take your car to the dealership and have them hook it up to a diagnostic computer and reset the sensor.
how i reset check enging light manually at mitsubishi fuso 4m50
You can either go to a mechanics shop to have the check engine light reset or you can do it manually by yourself. You will need to remove the negative battery terminal for 1 minute and then reconnect it.
You can try disconnecting the negative battery cable for 5 minutes. That may reset the light. If not you will need an OBD2 scan tool to reset it.
Disconnect the battery for about five minutes and that should reset the check engine light. Or, pull the 80 amp fuses in the small plastic compartment on top of the battery for about the same time.
The Check Engine light has nothing to do with oil changes and if it is on you have an emissions problem. The Maintenance Required light indicates you need an oil change. You must reset that light manually.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
how do i reset the check engine light on a 1999 acura 3.2tl
hoe do you reset the check engine light in a 1995 land rover
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
You need a scan tool to properly reset the check engine light.