answersLogoWhite

0


Best Answer

i'm pretty sure you just unhook the negative battery terminal and then rehook it.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset a computer on a 2001 Chevy Venture?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 2001 Chevy Venture have a fuel reset button?

no


Where is the reset button for fuel pump 2001 Chevy venture?

GM vehicles do not use inertia/reset switches.


How do you replace ac condenser on a 2001 Chevy Venture?

How do you replace ac condenser on a 2001 chevy venture?


Remove windshieldrear motor on a 2001 Chevy Venture?

replace rear window wiper motor on 2001 Chevy venture


Looking for chevy venture 2001 speed sensor that is located in the transmission?

where is the speed sensor for the transmission located in 2001 chevy venture


How do you reset the computer error codes on a 2001 Chevy blazer?

It will be to the left of the thermostat housing, in the intake.


How do you reset the o2 sensor on an 2001 Chevy Prism?

There isn't a reset for the oxygen sensors. When a repair is made then you need to have the computer cleared.jd


How do you reset the service light on a 2001 Chevy Cavalier?

disconeect the battery for a few minutes that will reset the computer and remove the service light signal


2001 Chevy Venture fuse box diagram. We bought a used 2001 Chevy Venture and I need to change a few fuses but I am not sure of the numbers for them any suggestions?

Hi. they have one on my-Chevy-venture.com i have a 2001 Chevy venture also and after doing some searching on it i came across that page it explains alot


How many miles must be driven after computer is reset on 2001 Chevy Tahoe?

5 to 6 miles at the most.


What is the brake bleeding procedure for a 2001 Chevy Venture Van?

How bleeding brake .01 chevy venture. Master cylinder replace


2001 Chevy Tracker fuel cut off switch location and how to reset?

Chevrolet doesn't use reset switches. The system is computer controled with relays.