To reset the service light on a 1.2 VW Polo, first turn on the ignition without starting the engine. Then, press the accelerator pedal three times within 10 seconds. After this, turn off the ignition and then start the engine to check if the service light has been reset. If it remains on, you may need to repeat the process or consult the vehicle's manual for specific instructions.
Posted: Thu Sep 02, 2004 12:35 pm Post subject: Reset Engine Service Light - Saab 900 all years ---- Reset Engine Service Light - Saab 900 all years To clear "TIME FOR SERVICE" from the Saab Information Display, press and hold the "CLEAR" button for at least 8 seconds. A signal will be heard indicating reset. After the 21st restart of the vehicle, the "TIME FOR SERVICE" message will be cancelled.
AnswerSwith the Ignition OffHold Miloemeter Trip Reset In (keep held in)Turn on IgnitionStill Hold Trip Reset for approx 12 seconds, the InSP should change.Release trip reset.Switch off ignitionSwitch on ignition and check.
There are 3 stages locate the obd plug and find pin 8 then turn ignition to pos 2 with a fused wire ( a piece of wire with a fuse in it) ground pin 8 for 4-5 seconds turn ignition off repeat this procedure 2 more times but for 8-12 seconds and then the service indicator will be reset.
Service intervals for a Volkswagen Polo typically vary based on the engine type and driving conditions. Generally, it is recommended to service the Polo every 10,000 miles or 12 months, whichever comes first. However, some models may have longer intervals of up to 20,000 miles depending on the specific engine and oil type used. Always refer to the owner's manual for the most accurate information regarding service intervals for your specific model.
Roberto Polo was born on 1980-12-21.
Press the trip count reset button and put your foot on the brake at the same time, when engine is switched off. Wait 12 seconds and turn ignition on. that should do the trick. it worked for me on my Vectra 2.2 auto petrol and it also worked for my son on his 2.2 auto desiel .
Hey Carol==Press the trip/oil reset button on the dash for about 12 seconds. When the light flashes, it is reset. GoodluckJoe turn on and off the igition switch three time's at third time leave no this should do it. If you turn the ignition to the on position and tap the gas three times quickly it should turn the light off.
To reset the 'maintenance required' light on a 2012 Toyota RAV4, start by turning the ignition key to the "ON" position without starting the engine. Press the gas pedal slowly three times within five seconds. Then, turn off the ignition. When you start the car again, the maintenance light should be reset.
Just push in the clock adjuster and start engine hold down for 12 seconds it will clear
Browning.com has sn data under customer service.
1. Ignition position 12. Press and hold reset button. Trip Meter3. Ignition position 24. Meter flash and start car immediately.Cheers... Helped me twice. Volvo S80 owners for 12 years.Eddie P
To reset the security light on an Oldsmobile vehicle, first the driver must turn the key to the "on" position, without starting the engine. Next, he or she should turn the key to attempt to start the engine, but not completely, so that it doesn't start before moving the key back to the "on" position. After about 12 minutes, the light will?æbe reset, and the key should be removed.?æ