The type of sensor used is sacrificial in design and must be replaced once the pad wear indicator has been activated on the relevant wheel. When replacing the pads, disconnect the sensors one at a time, front and rear, and test for continuity (complete circuit) with a multimeter or test lamp and 12volt power source. The faulty sensor, which will in normal circumstances will be the front left one, will not reveal a complete circuit and you have now located the "fault". Replacements may be ordered from your dealer.
Alternatively, to "reset" or clear the displayed fault from your dash, you have only to complete the circuit of the sensor cable! No resistors are required to be fitted to achieve this.
It should be further noted that pads and discs should be replaced at the same time as they are designed to wear together, replacing the discs does not entail fitting new wheel bearings as the discs mount directly to a spindle hub and are retained by one countersunk screw until the wheels are refitted, machining of the discs is not recommended.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
How do you reset the brake pad warning light for a 2005 c320 mercedes benz?
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
how do you reset brake warning light 0n 745li bmw
You can reset the brake warning lights, on your VW Jetta, by backing up 20 feet and using the brakes. The automobile will sense the new pads and the warning light will go off.
Replace the brake pads.
how can i reset rear brake pad warning light on 2006 bmw 525i
One can reset the brake warning light on the discovery 3 by resetting one's brake pads to the original manufacturer's settings and checking if they have been worn through.
You have a problem with the brake system. Once you repair the problem the light will reset itself.
Press the reset button
Add brake fluid
Have you tried turning it off and on again.